blanking time
英 [ˈblæŋkɪŋ taɪm]
美 [ˈblæŋkɪŋ taɪm]
网络 消隐时间; 空白时间; 遮没时间; 熄灭时间; 间隔时间
双语例句
- There are actually two concurrent forms of software radar blanking being developed at the time of writing.
实际上在编写本文的时候就有两个雷达消除软件正在发展。 - The CCAP programming software is adopted for blanking piece so as to reduce the auxiliary time, improve production efficiency and then enhance utilization ratio of equipment.
采用CCAP编程软件进行下料件的程序编制，减少生产时的辅助时间，提高生产效率，进而提高设备利用率。 - While polygon vertex algorithm was used for blanking part layout optimization, with optimization precision improving and search space sharply increasing, traditional optimal calculation method has a few defects, such as large calculation quantity, long time consumption.
应用多边形顶点算法进行排样优化计算时，随着优化精度提高，其搜索空间将急剧增大，导致传统的求解方法计算量大、耗时多。 - This thesis develops a kind of constant flow blanking plug with simple structure, long useful time and low costs.
本文研制了一种结构简单、使用寿命长、成本低的油田恒流注水堵塞器。 - A simplified analytic method was put forward to determine the pressure center of blanking die for workpieces with complex shape to lighten the work of calculating for designers and to save the time.
对形状复杂工件用解析法确定冲模压力中心，计算繁琐，工作量很大，因此提出简化解析法确定压力中心，采用本方法可大大减轻设计人员的计算工作量，节约时间。 - This dissertation introduces the principle of the on-line UPS, and the SPWM technology for the UPS inverter is also discussed. The effect of blanking time on the output voltage in PWM inverters and the methods to eliminate it is described.
本文首先介绍在线式UPS的基本原理以及逆变器的SPWM调压方法，研究死区对逆变器输出电压的影响及其补偿方法。 - In process of data processing, we used the techniques, such as filtering, edition surgical blanking, prediction deconvolution, fitting static correlation of first arrival time, and velocity analysis, and obtained a high-qualitative shallow seismic reflection sounding profile.
数据处理过程中采用了滤波、编辑切除、预测反褶积、初至时拟合静校正和速度分析等技术，得到了高质量的浅层地震反射探测剖面。 - The results show that the shear zone of workpiece can be heated by electrical current to an appropriate blanking temperature in a short time interval, which enables a sufficient reduction of the shear strength of the work material as well as the blanking force.
结果表明，电加热可在较短时间内在工件的冲切区形成合适的冲切温度，显著降低材料的破坏强度，从而可有效降低冲切力。